① 通達信。指標問題
刪除這句
STICKLINE(FILTER(C,60)>0,高點,低點,0.5,0),COLORRED;
或在後面加上,NODRAW變成：
STICKLINE(FILTER(C,60)>0,高點,低點,0.5,0),COLORRED,NODRAW;
豎線消失
參數Q為9.不知源碼中的Q為多少
所畫的每小時分界線參照分時圖上的格線。
② 麻煩老師把下面通達信分時公式改成預警公式 要求同時出現猛虎出籠信號時預警下面是公式源碼
A1:=AMOUNT/VOL/100;
A2:=(3*HIGH+LOW+OPEN+2*CLOSE)/7;
A3:=SUM(AMOUNT,40)/A1/100;
A4:=SUM(AMOUNT,80)/A1/100;
B1:=DMA(A2,VOL/A3);
B2:=DMA(A2,VOL/A4);
B3:=(CLOSE-B1)/B1*100;
B4:=(CLOSE-B2)/B2*100;
現價:=C;
分時確認:=MA(REF(HHV(C,60),1),2);
均價:=SUM(現價*V,240)/SUM(V,240);
回調認同:=EMA(EXPMA(C,20),13);
分時壓力:=MA(REF(HHV(C,30),1),2);
分時支撐:=MA(REF(LLV(C,30),1),2);
RSV:=(CLOSE-LLV(LOW,Q))/(HHV(HIGH,Q)-LLV(LOW,Q))*100;
K:=SMA(RSV,5,1);
D:=SMA(K,3,1);
J:=3*K-2*D;
VAR2:=EMA(J,6);
VAR3:=(CLOSE-LLV(LOW,21))/(HHV(HIGH,21)-LLV(LOW,21))*100;
VAR4:=SMA(VAR3,13,8);
VAR5:=CEILING(SMA(VAR4,13,8));
VAR6:="SSRP.MA1";
VAR7:="SSRP.MA2";
SIGNAL1:=CROSS(VAR5,VAR2) AND C>=均價;
SIGNAL2:=(CROSS(VAR5,VAR2) AND B3>0.6 AND C>=均價);
SIGNAL3:=(CROSS(VAR6,VAR7) AND B3>0.6 AND C>=均價);
XG:SIGNAL1 AND (SIGNAL2 AND VAR6>VAR7) {OR (SIGNAL3 AND VAR5>VAR2)};
③ 麻煩老師將下面通達信分時指標做成預警公式 要求 同時出現 虎 出籠 信號選中預警
A1:=AMOUNT/VOL/100;
A2:=(3*HIGH+LOW+OPEN+2*CLOSE)/7;
A3:=SUM(AMOUNT,40)/A1/100;
A4:=SUM(AMOUNT,80)/A1/100;
B1:=DMA(A2,VOL/A3);
B2:=DMA(A2,VOL/A4);
B3:=(CLOSE-B1)/B1*100;
B4:=(CLOSE-B2)/B2*100;
均價:=SUM(C*V,240)/SUM(V,240);
RSV:=(CLOSE-LLV(LOW,Q))/(HHV(HIGH,Q)-LLV(LOW,Q))*100;
K:=SMA(RSV,5,1);
D:=SMA(K,3,1);
J:=3*K-2*D;
VAR2:=EMA(J,6);
VAR3:=(CLOSE-LLV(LOW,21))/(HHV(HIGH,21)-LLV(LOW,21))*100;
VAR4:=SMA(VAR3,13,8);
VAR5:=CEILING(SMA(VAR4,13,8));
VAR6:="SSRP.MA1";
VAR7:="SSRP.MA2";
SIGNAL1:=CROSS(VAR5,VAR2) AND C>=均價;
SIGNAL2:=(CROSS(VAR5,VAR2) AND B3>0.6 AND C>=均價);
SIGNAL3:=(CROSS(VAR6,VAR7) AND B3>0.6 AND C>=均價);
SIGNAL1 AND SIGNAL3 AND VAR5>VAR2;
{根據分析，「出籠」為紅色時勝率比粉色高，粉色過於頻繁故不預警。但通達信好像不支持分時預警}。